Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

did extension doesn't appear on mobilephone?

dear sir,

Our environment have 1 publisher and 1 subscriber in a cluster. Both ccm version 4.1(3)sr2 . We have cisco3725 which are running mgcp services for pstn. We felt weird why when we perform outbound calls to our mobilephone for testing. We cannot see the DID from the extension number appear on our mobilephone? We can only see the pilot number appeared? For example:- The pilot number is 1110000 and the extension number is 33333 . By right, we should see 1113333 appear on our mobile phone? We can only see 1110000 appear on the mobile phone. we perform a debug isdn q931. It always show the "calling number is 222XXXX" number. Maybe 2221234 sometimes. Any idea? please advise. Please provide guidance. thank you very much.

2 REPLIES

Re: did extension doesn't appear on mobilephone?

In your Calling Party Transformations

Use Calling Party's External Phone Number Mask

(route list in CallManager)

Is this set correctly to "ON"?

New Member

Re: did extension doesn't appear on mobilephone?

hi tcatlinins and all,

thank you for your helps. I've tried but same problems, can't appear the correct extension did on the mobilephone.

Here's the sample debug isdn q931

*Jul 23 06:09:37.733: ISDN Se1/1:15 Q931: TX -> SETUP pd = 8 callref = 0x03A9

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98382

Exclusive, Channel 2

Display i = 'Spsn IT Regional Helpdesk'

Calling Party Number i = 0x0081, '33800'

Plan:Unknown, Type:Unknown

Called Party Number i = 0x80, '0125667835'

Plan:Unknown, Type:Unknown

I hope the "Calling Party Number i = 0x0081, '33800' " should appear '8883800' ?

Any idea how to do that? please advise. thank you .

118
Views
3
Helpful
2
Replies