Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
ird
New Member

did on cme problem

Hi, trying to get direct access from pstn to internal extensions I used translation rules applied to dial-peers.

The problem is that with this configuration just one incoming call can be received at a time.

the following config is the one that I've tested, our 2821 router is connected to 4 isdn bri that have the public numbers routed and are in a jump group created by the telco, cme is ver 3.3.

Does anyone know which could be the problem?

Does anyone have a real working exemple?

thanks a lot.

greetings for that forum

configuration:

voice translation-rule 1

rule 1 /902321400/ /2000/

rule 2 /932183737/ /2000/

rule 3 /933683011/ /2100/

rule 8 /932388298/ /2800/

rule 9 /932388299/ /2101/

rule 10 /932388300/ /2301/

rule 11 /932388296/ /2500/

rule 12 /932388297/ /2601/

rule 13 /933683014/ /2701/

rule 14 /902116855/ /2702/

rule 15 /933683010/ /2703/

!

!

voice translation-profile als_2xxx

translate called 1

!

voice-port 0/0/0

compand-type a-law

cptone ES

connection plar 2000

!

voice-port 0/0/1

compand-type a-law

cptone ES

connection plar 2001

!

voice-port 0/1/0

compand-type a-law

cptone ES

connection plar 2002

!

voice-port 0/1/1

compand-type a-law

cptone ES

connection plar 2003

voice-port 0/0/0

compand-type a-law

cptone ES

!

voice-port 0/0/1

compand-type a-law

cptone ES

!

voice-port 0/1/0

compand-type a-law

cptone ES

!

voice-port 0/1/1

compand-type a-law

cptone ES

!

dial-peer voice 1 pots

translation-profile incoming als_2xxx

destination-pattern 0T

incoming called-number .

direct-inward-dial

port 0/0/0

dial-peer voice 2 pots

translation-profile incoming als_2xxx

preference 2

destination-pattern 0T

incoming called-number .

direct-inward-dial

port 0/0/1

!

dial-peer voice 3 pots

translation-profile incoming als_2xxx

preference 3

destination-pattern 0T

incoming called-number .

direct-inward-dial

port 0/1/0

!

dial-peer voice 4 pots

translation-profile incoming als_2xxx

preference 4

destination-pattern 0T

incoming called-number .

direct-inward-dial

port 0/1/1

2 REPLIES
Blue

Re: did on cme problem

Its most likely that your carrier is not set properly to roll the next call over to the member of the trunk group.

please rate posts.

andy - berbee

ird
New Member

Re: did on cme problem

Thanks, but when I use "connection plar" on the voice ports they can receive several calls at the same time, and the old telephony system worked well with this trunk.

105
Views
0
Helpful
2
Replies
CreatePlease to create content