Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

DID on MGCP port

I setup a CAS t1 trunk in a MGCP gateway and I don't seem to get DID working properly. I am confused as whether this is a CCM or a Gateway setting. I tried to configure incoming dial peers with DID in the gateway as I saw in examples in Cisco website but with no results.

Also, can CCM manage a t1 trunk via MGCP and another trunk via H323 on the same gateway??

2 REPLIES
Blue

Re: DID on MGCP port

Yes, you can have both MGCP and H323 controlled ports on the same router.

DO you have your DS0 group set for E&M?

The next thing to check would be the Calling Search Space on your gateway. It must be able to see the internal DNs.

Can you post your router and CCM gateway configs?

Dave

Community Member

Re: DID on MGCP port

Dave thanks for your prompt reply. I am not sure on how to extract the config seetings in CCM and post them here (PrintScreen does not work here). If you tell me how I'll be happy to do so. I am not sure as to what you refer to with "Calling Search Space in your Gateway", are you refering to the dial-peer settings??. Here is the config settings for mgcp in my gateway. Adding, removing the DID statement in the dial-peer has not effect. I also tried to add the "incoming called-number ." to it with no results again. I have checked CCM settings for this CAS port and I don't see any definitions for DID that I can play with.

Thanks for your help

controller T1 0/2/0

framing esf

linecode b8zs

ds0-group 0 timeslots 1-24 type e&m-wink-start

.

.

.

voice-port 0/2/0:0

!

ccm-manager mgcp

!

mgcp

mgcp call-agent w.x.y.z service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

mgcp rtp unreachable timeout 1000 action notify

mgcp modem passthrough voip mode nse

mgcp package-capability mf-package

mgcp package-capability rtp-package

mgcp package-capability as-package

mgcp package-capability script-package

no mgcp package-capability res-package

mgcp package-capability sst-package

no mgcp package-capability fxr-package

mgcp package-capability pre-package

no mgcp timer receive-rtcp

mgcp sdp simple

!

mgcp profile default

!

sccp ccm w.x.y.z identifier 1 version 4.1

.

.

.

!

dial-peer voice 1 pots

service mgcpapp

direct-inward-dial

port 0/2/0:0

121
Views
0
Helpful
2
Replies
CreatePlease to create content