Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Digit Manipulation help

Hi Guys,

I have just setup a new site and want to enable local dialling (0544 XXX XX)but across the WAN instead of the pstn as i am having problems with the local BRI circuits.

Basically i want to expand the local number to the full E164 (0039) on ccm.On the route list i have predot to discard the 0 for outside line.

Secondly,i get an awful noise on incoming calls on my BRI`s and therefore speech is barely audible.Site location in Italy.

Any help much appreciated !!

1 REPLY
Cisco Employee

Re: Digit Manipulation help

please provide an example of what you want to dial, what you want to send over the WAN and what's the destination's phone DN

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
106
Views
0
Helpful
1
Replies
CreatePlease to create content