Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Hall of Fame Super Gold

Digit strip in 12.4XC4

[pls excuse duplicate post]

I thought that the main usage of digit strip was to remove the matched pattern for an outbound pots call.

I run 12.4.XC4 with CCME 4.0(3), digit strip on a destination pattern of ^0T is not removing the 0 and passes the dialed number unchanged to a BRI voice port.

I had to use a translation rule to remove the leading 0.

Did I misunderstood the usage? How can check that digit strip is working or not when dialing out ? Calls are made from skinny phones.

1 REPLY
Bronze

Re: Digit strip in 12.4XC4

hi,

why you are using ^0T as destination pattern?

try it with 0T and the 0 will be stripped.

you needn't use any translation pattern to strip the leading 0.

regards

mehmet

113
Views
5
Helpful
1
Replies
CreatePlease login to create content