Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Digit Timeout - what service parameter

The phone goes back to dial tone after about 2 seconds in the middle of

referencing a phone number to dial. Example, 724 (after a few seconds it goes to dialtone). Is there a service parameter to adjust this time.

I know there is the Off-hook to first digit parameter, but is there a parameter for any digit that follows the first? Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: Digit Timeout - what service parameter

Hello,

Is this an internal number or external number.If it is external number then that means calmanager is finding a match after 724 and it is giving a dialtone.

If you are looking for interdigit timeout it is T302.But I don't think that is the problem

Thanks,

Radhika

3 REPLIES
Bronze

Re: Digit Timeout - what service parameter

Hello,

Is this an internal number or external number.If it is external number then that means calmanager is finding a match after 724 and it is giving a dialtone.

If you are looking for interdigit timeout it is T302.But I don't think that is the problem

Thanks,

Radhika

Community Member

Re: Digit Timeout - what service parameter

It is an external number.

VIP Purple

Re: Digit Timeout - what service parameter

It's the T302 timer. Please see the document below.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800dab26.shtml

Hope this helps.

Brandon

116
Views
0
Helpful
3
Replies
CreatePlease to create content