According to digit manipulation information available for CCM 4.0, It is said that 'discard digits assignments' can be done in Route pattern and also inside the route group configuration. I have not found the place where to do this in the route group configuration. Could somebody make this a little bit clear to me.
Thanks for your help on our doubt. But I have been examining one of the route-list in our CCM and I do not see any field related to digits manipulation. The 2 route-groups included in this route-list are ISDN QSIG E1s. and the question is: What is the dependency of the route-group so that we can manipulate digits in the route-list?
Go to the route-list configuration. On the left site you have route-groups which are components of this route-list. Click on one of them and you will see configuration of digit manipulation (discard digit, prefix, etc.)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.