Does anyone know a work around on how to get DISA type functionality from either the Call Manager or Unity. We are just looking to call in from the PSTN (e.g. DID ) to the CM or Unity, then get dialtone and dial back out. Thanks
I haven't had time to pilot this in the lab, but I think this would be the way to do it. You could configure your 26xx/36xx/as53xx IOS gateway with the IOS IVR. You would have an inbound dial peer for a specific DID that routes to the IOS IVR. The IVR would challenge for credentials (ACS or local) and then allow secondary dial-tone for an out-bound call. It would be nice to hear from the CCIE moderators on whether this would be feasible or not.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.