Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Disable T1 with CCM 4.1.3 and MGCP

Is there a way to disable or place a t1 into a maintence state from the web interface? I need a way to keep traffic off of a t1 while testing things without having to change alot of programing. I know I can do a shutdown from the router but is there anything avalible from the web interface?

1 REPLY
Silver

Re: Disable T1 with CCM 4.1.3 and MGCP

Yes, on a T1 PRI. Not on a T1 CAS.

For the T1 PRI you can use the service parameter "Change B-Channel Maintenance Status" to place it in maintenance.

Make sure you check the "Enable Status Poll" at the gateway.

Regards,

Anup

88
Views
4
Helpful
1
Replies