Does anyone know if it is possible to disable inbound caller ID on Call Manager 3.1(2c) with a 6608 gateway using a PRI? If so, how? The presentation bit takes care of the outbound, but my client wants to block inbound CLID as well.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
There is a box under the route pattern setup that will let you do that. Go under the route patterns and check that box and then go to the users in question and put in a transform mask wild card. I think it is * . Email me if you have a problem.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...