Running CCM 4.1, we have some alerts setup in RTMT to email people when certain events happen. The schedule feature only allows us to set a begin and end time per day and doesn't allow us to exclude weekends. This causes people to get email bombed on Saturday's, Sunday's, and holidays.
I dug around for a bit in the CCM database to see if there was a table that stored the disabled/enabled state of each alert without luck. Does anyone know where this status is stored and/or if there is a way to disable/enable alerts outside of the RTMT? I would love to be able to run a script to modify these. Thanks in advance!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...