we are setting up a test lab of termination in cisco as5300 using R2 signaling in POTS line. However I have problems that everytime we terminate the calls stripping the number countrycode and areacode..and call only the telephone number, I have a disconnect cause code 19 thus the caller did not accept the call or nobody answer. This is strange because I am calling my office desk telephone number.
See below my config for your reference.
dial-peer voice 19 voip
session target ras
dial-peer voice 101 pots
Do you have thoughts, or there is lacking or something to modify in my configuration.
Hi John - can you give us a snapshot of your "debug isdn q931"? What number are you dialling - it's unusual that your voip and pots destination patterns are the same, but I don't know what you're trying to dial.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...