When running the LearnTones utility I got the following error message: "Function timed out" and it did not find the tone's frequencies except for the ringback tones parameters. I want to use this utility because the ports (dialogic-analog) take to much time to disconnect after a user hangs up. Any ideas on how to reduce the time ? For now it takes about 2 minutes which is way too long...<br>Thanks,<br>-norm<br><br><br>
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...