I'm using Ezenia's Encounter 3000 Gateway(version 1.0.1) together with Cisco MCM running in a C2500.
I have a problem with H323 endpoints calling via the Gateway to H320 endpoints. After 10 minutes the call disconnects. The same happens if I start a conference from the MCU and invites the H320 endpoint. But if the H320 endpoint is calling into the Gateway it is working fine.
So it only happens when a call is initiated from the inside and the call is always disconnected after 10 minutes.
CSCds42519 - Random reboots of IP/VC 3510, IP/VC 3520, and IP/VC 3525 units running version 2.1 software. Also, are the calls bonded correctly? What are you using for QoS - LLQ, etc. How is the bandwidth on your local net during the VC sessions?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.