We have a Unity 3.1.5(200 Users,12 Sessions,VM) integrated with CM with the following config-
Compaq DL320,HD-17 GB,RAM-256 MB,PIII
C:\-6 GB,Unity is installed in this drive
e:\-11 GB-Exchange 2000 is installed
Subscriber created-Around 120
System is not connected to existing domain & is a domain controller in its own domain.
1.We want to add another HD & mirror(Software mirroring) with the existing HD.
How safe is this ie converting the existing HD to dynamic & mirroring ....
existing RAM usage is around 80%.Is the existing hardware sufficient to support software mirroring.
Should we take a backup before going ahead?we have Unity disaster recovery tool 1.0 Build 76.Can we backup & restore both unity & exchange 2000 database using this.What are the precautions should I take before & after backup if the HD crashes & I need to reinstall.
2.Reports-In Subscriber Message Activity report ,the Sender field shows Unknown Caller.Should I configure something in Unity or CM to see Caller ID.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.