I'm busy upgrading a CallManager 4.1(3) cluster to 6.0. Ran DMA, and got the TAR file. I install UC6.0, and when I get to the point where it pulls the .tar file from my SFTP server, straight after, it gives me an error "DMA File Validation failed: No DMABackupInfo.inf file was found". I have opened the .tar file with winzip, and the file is there. i even opend the file, and it gives me all my network details, and I have made sure that this is all the info I used when i build the new server. Any ideas?
It said it was successful, but had warnings. I checked the warnings, and it was just with names like Du Plessis, with a space. The DMA file I used was 104mb, so last night I decided to restart the DMA backup, which takes 12.5hours, and it created a DMA file of 119mb. As this is in my lab, and nothing has changed, it obviously did not finish so successful as I thougt at first. So far it is importing, and it went past the previous error. Let's see what what that delivers. Thanks for your help anyway, as I would never have thought the DMA is corrupt.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...