Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Do you need DSP's for a HWIC-4B-S/T

Hi,

It's been a while since I deployed any new voice routers, I have a need for 8 BRI ports on a new router, do I need a PVDM DSP chip for this? I am looking at a 2901 with 2 HWIC-4B-S/T

Thanks

Jon

Everyone's tags (6)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Do you need DSP's for a HWIC-4B-S/T

No. You install them directly on the chassis together with the PVDM3.

Please remember to rate useful posts clicking on the stars below.

3 REPLIES
Hall of Fame Super Gold

Re: Do you need DSP's for a HWIC-4B-S/T

HWIC-4B-S/T does not support voice, and does not requires DSP to work for its data-only functions.

for 8 BRI, you will need 4x VIC2-2BRI-ST/TE and a minimum of PVDM3-16.

New Member

Do you need DSP's for a HWIC-4B-S/T

Thanks Paolo,

I'll need to check exactly which BRI module is on our existing setup.

Asssuming I need 4 X VIC2's would I need to put those on a HM-HD-2V? (and therfore need a bigger router than a 2901)

Thanks

Jon

Hall of Fame Super Gold

Re: Do you need DSP's for a HWIC-4B-S/T

No. You install them directly on the chassis together with the PVDM3.

Please remember to rate useful posts clicking on the stars below.

632
Views
0
Helpful
3
Replies