Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

does barge require resource

Does barge and cbarge in ccm 4.x require media resource, either software or hardware or use built in dsp in the phone?

1 REPLY
Green

Re: does barge require resource

Barge allows a user to get added to a remotely active call that is on a shared line. Remotely active calls for a line comprise active (connected) calls that are made to or from another device that shares a directory number with the line. Barge supports this type of remote-in-use call.

Phones support Barge in two conference modes:

?Built-in conference bridge at the target device (the phone that is being barged). This mode uses the Barge softkey.

?Shared conference bridge. This mode uses the cBarge softkey.

The original call requires G.711 codec. If G.711 is not available, use cBarge instead.

Info here:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803f3a86.html#wp1054483

130
Views
0
Helpful
1
Replies
CreatePlease login to create content