Does the message lamp work for CCM IP phones using Intuity Audix
We currently have a Definity G3si, CCM, and Intuity Audix 4.1. The Definity is connected to the CCM through PRI and the Audix is connected normally to the Definity. I need to know if it is possible to make the message lamps light up on the CCM IP phones from the Audix.
Re: Does the message lamp work for CCM IP phones using Intuity A
The Audix system you have would need to have an SMDI port that you could connect to the CallManager in order for this to work, as well as some analog or digital ports to connect to a Skinny or MGCP gateway connected to CallManager.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...