Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

does this scenario works ?

Hi,

I have the following scenario:

PSTN---fxo2611a-----t1-----2611b-fxs-----phone (x2110)

2611a config:

dial-peer voice 1 pots

destination 9T

port 1/0

dial-peer voice 2 voip

destination 2...

session-target ipv4: 1.1.1.2 (ip address of 2611b router)

2611b config:

dial-peer voice 1 pots

destination 2110

port 1/0

dial-peer voice 2 voip

destination 9T

prefix 9

session-target ipv4: 1.1.1.1 (ip address of 2611a router)

Thanks for all inputs.

Duc Vu

2 REPLIES
New Member

Re: does this scenario works ?

I had tried and it worked fine...only need to put in command "prefix 9" under dial-peer voice 1 pots on 2611a router.

New Member

Re: does this scenario works ?

I think what you need put command "forward digits" in the router conected to PSTN (in the dial/peer pots, may be in the other router too), and may be work in the WAN conection with "IP RTP Priority" for forward the voice packets more quickly than the data packets.

104
Views
0
Helpful
2
Replies