We have a customer who runs a clinic where he needs a door latch system. The client will NOT have a pager at the door - the receptionist will need to physically see the patient walk to the door, then "Buzz" it open.
We can permantly designate a button for this feature if needed.
They have a 12V Electric Door Strike installed. Does anybody have a config or experience with this that they can share?
I have it to the point where the Viking RC-3 answers, but it then beeps twice and waits for the caller to enter digits to trigger one of the three relays.. I'm requesting from Cisco TAC that they provide a way for the UC540 to delay sending digits until after the Viking device answers
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...