Downloaded version of Unity 3.0(3), can It be used
Dear All,<br><br>If I download all 5 CD from Cisco software download site can I do a full install of Unity? Is there anything different between the real version (the one you buy) or the downloadable version?<br><br>From Rif<br><br>
Re: Downloaded version of Unity 3.0(3), can It be used
Just to clarify...
The CDs on CCO are the exact same software you would get if you were to buy Unity. None of the necessary Microsoft components are available of course.
If you do not have a key Unity will run in a 2 port demo mode. If you happen to have a 2.X key and have a SASU support contract you can order an upgrade at http://www.cisco.com/upgrade. Cisco does not support upgrading from 2.X to 3.X without ordering an upgrade kit. Cisco TAC also does not support the demo version of Unity. You will need to post any questions you have out here on this forum.
Keith Chambers Unity Technical Lead Unified Voice Team, San Jose Cisco Systems email@example.com
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.