Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

DPA 7630

I am trying to add a DPA 7630 gatway to my Octel I am having problems getting DHCP. It is registered with the DHCP scope but my MAC addr. is two digits short. When I try to change it on the DPA it only allows 10 dugits and the SEP at the front of the MAC. I had it getting DHCP and now it will not it is registered on my publisher.

2 REPLIES

Re: DPA 7630

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Cisco Employee

Re: DPA 7630

Sounds like you are using the wrong MAC addresses. If the DPA is getting an IP address but failing to register to CallManager, you can either enable auto-registration on the CallManager and have the DPA ports register that way, or read this URL which explains how to calculate the device names of the DPA ports:

http://www.cisco.com/univercd/cc/td/doc/product/voice/c_access/7630adpt/7630_10/admin_gd/7630plan.htm#xtocid143325

95
Views
0
Helpful
2
Replies
CreatePlease to create content