Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DSP and toll bypass (how to use DSP Calc)

If I'm deploying G.729 across WAN and G.711 inside LAN in a 2-site IPT, with one voice gateway with PSTN termination, as PSTN connectivity is typically always via G.711, in which field on DSP Calculator should I provision the number of toll bypass calls, as terminated in G.729? Or should I fill out the number of xcode sessions field instead?

Another question: when provisioning mixed confs (G.711/G.729 users), the same DSP is also performing xcode, and which type of code is the audio being mixed to?

Thank you

1 REPLY
Bronze

Re: DSP and toll bypass (how to use DSP Calc)

You can fill out the number of xcode sessions field

207
Views
0
Helpful
1
Replies