12-03-2005 09:07 PM - edited 03-13-2019 11:26 AM
2821 router with NM-HDV2-2T1/E1.
Two PVDM2-64 on motherboard slot 0,1
Two PVDM2-32 on NM-HDV2-2T1/E1 slot 0,1
issue: two PVDM2-64s are working fine, but the two PVDM2-32 on NM-HDV2-2T1/E1 are not shown up anywhere for confiuration.
Any suggestions?
12-04-2005 12:57 PM
Hi yanhui,
The show diag should show you those PVDM2-32.
Good commands:
test voice driver
show voice dsp
test dsprm N (N is the chassis slot number where the NM-HDV2 is installed)
Check this very good reference:
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c316.shtml#t2
12-04-2005 07:56 PM
use "show diag", I can see PVDM2-32s, according this doc. I don't need to configure. it seems working.
thanks!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: