Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DSP configure

2821 router with NM-HDV2-2T1/E1.

Two PVDM2-64 on motherboard slot 0,1

Two PVDM2-32 on NM-HDV2-2T1/E1 slot 0,1

issue: two PVDM2-64s are working fine, but the two PVDM2-32 on NM-HDV2-2T1/E1 are not shown up anywhere for confiuration.

Any suggestions?

2 REPLIES
Green

Re: DSP configure

Hi yanhui,

The show diag should show you those PVDM2-32.

Good commands:

test voice driver

show voice dsp

test dsprm N (N is the chassis slot number where the NM-HDV2 is installed)

Check this very good reference:

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008039c316.shtml#t2

New Member

Re: DSP configure

use "show diag", I can see PVDM2-32s, according this doc. I don't need to configure. it seems working.

thanks!!

134
Views
0
Helpful
2
Replies