I have a VG200 DSP far with 4 simms. I've confifigured the necessary commands for set up and the thing seems to register fine with CM. However, when we attempt to set up a conference we get not audio. I see the DSPs going active and the IP addresses of the phones participating in the conference via debug "DSPfarm".
Turns out my problem was that I did not have ip routing turned on globally on the vg200. As soon as I activated IP routing things started working. I recall this problem when configuring a vg200 as a gateway. Must have ip routing active for the box to work.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...