Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

dsp module and ISM-SRE-300-k9

Hi

i have a couple of questions regarding this,

when i had installed the pvdm3-64 module on an 2921 running a cme , do i need to configure anything else or the resources are already aviable?

And could anyone post a link for the phisycal instalation guide od the ism-sre-300-k9 on a 2921, because im no been able of findinf it.

thankn in advance

Cesar

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: dsp module and ISM-SRE-300-k9

Same as ny other CUE

Make ip addres unnumbered from the voice vlan interface.

service-module use an address from same subnet.

static route /32 pointing to ism0/0

That is also in the guide.

3 REPLIES
Hall of Fame Super Gold

Re: dsp module and ISM-SRE-300-k9

q1: no

q2: 2921 hardware installation guide, "installing internal modules".

Re: dsp module and ISM-SRE-300-k9

actually the installation went ok, but im unable to ping the service module

interface ism 0/0

ip address 10.0.0.1 255.255.255.0

service-module ip address 10.0.0.2 255.255.255.0

service-module default gateway 10.0.0.1

anything wrong in here?, actually its traight from the configuration guide

regards

Cesar

Hall of Fame Super Gold

Re: dsp module and ISM-SRE-300-k9

Same as ny other CUE

Make ip addres unnumbered from the voice vlan interface.

service-module use an address from same subnet.

static route /32 pointing to ism0/0

That is also in the guide.

868
Views
5
Helpful
3
Replies