Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

DSP resource in 7200VXR

I had a PA-VXA-1TE1-24+ installed on 7200VXR. I want to use the 7 DSPs on the card to do transcoding in CCM. How can I add these in the CCM 3.3? In CCM, when you add a transcoder, you need to MAC for the port. Why is that? I am not clear about the transcoder/DSP concept and the way to configure it. I appreciate any help or refence doc.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: DSP resource in 7200VXR

The DSPs in a 7200 are not supported to be used as a Transcoder with CCM. This doc explains the supported hardware for CCM 4.1(3).

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edac1.html

Here is a doc that explains how to configure IOS based transcoders with CCM.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080334294.shtml

Kevin

2 REPLIES
Cisco Employee

Re: DSP resource in 7200VXR

The DSPs in a 7200 are not supported to be used as a Transcoder with CCM. This doc explains the supported hardware for CCM 4.1(3).

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803edac1.html

Here is a doc that explains how to configure IOS based transcoders with CCM.

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_configuration_example09186a0080334294.shtml

Kevin

New Member

Re: DSP resource in 7200VXR

Thanks for your great help.

136
Views
0
Helpful
2
Replies
CreatePlease to create content