One possible reason could be that the DT24+ gateways are already up with 8 bit loads. Since 3.3.2 comes along with 12 bit loads, the DT gateways do not come up. Solution is to rename the current 12 bit load in the CM to 8 bit load by truncating the last 4 digits, modify the "device default" page in the CM administration page to have the modified 8 bit load.
The cards had been uninstalled for several months before I recently attempted to put them back into service.
I moved the cards to another dhcp server & subnet and pointed to a different CM cluster. I get Transient Device Connect events in the app. log which indicates that the phones are attempting to register (had not been config'd yet). As soon as I add the gateway configs in CM the event messages stop and the cards never register.
I'm going to guess that the issue is related to the device load. I seem to recall that on the 7935s there was an issue where one could not go directly from a specific (old) load to what was then the latest load. There was an intermediate firmware that had to be loaded before going to the latest. Perhaps something similar is going on with these? I believe these were last used with a CM 3.1 build. I will try to connect these to a CM 3.2 system to see what happens.
For anyone interested the problem was the default behavior of the tftp service in CM3.3. The default parameters cache the .cnf.xml configuration files rather than write them to disk. The DT24s were therefore unable to find the config file and would not register. After changing the service parameters the config files were written to the TFTPPath directory and the DT24s registered with no further problem.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.