Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

DTMF Digits passing the Voice Gateway

Hi,

iam using Cisco 3825 router where E1 circuits are connected. Need to check the DTMF digits passing when i am trying to connect to an IVR number and the options digits pressed.

How can I get that.

Help required.

Thanks in Advance.

1 REPLY
Green

Re: DTMF Digits passing the Voice Gateway

Which VOIP protocol are you using?

If using MGCP check:

debug mgcp packet and look for NOTIFY messages. Check

mgcp dtmf-relay voip codec all mode out-of-band command is configured.

If H225 check dtmf-relay alphanumeric under VOIP dial-peers.

For checking debugs run debug h245 asn1

For TDM run:

debug voip vtsp tone

328
Views
0
Helpful
1
Replies
CreatePlease to create content