I have an issue with DTMF tranfer on Cisco UBE with H.323 to SIP interworking. On H.323 side (H.323 Trunk service from telco operator) DTMF comes ralayed using H.245 Signal method. One H.245 MSC userInput messages for each digit without information of duration. CUBE wait almost 4 seconds (default duration for this type of relay) before sending apprioprate RTP-NTE packets to SIP side.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...