I've just set up CCM3.0 and a 3600 gateway to test VOIP. The configurations is basic:
- 3600 gateway with a 2 port FXO vic connected to two pots lines.
- 3524 XL switch
- several IP phones connected to the switch.
We have the basic functionality working, but I am having an issue with passing DTMF tones to our IVR (voicemail) system. Everything I read states that I have to turn up an DTMF Relay, but I can't find anything that shows me how. Can anyone point me in the right direction?
On the voip dial-peer(s) that point to the CallManager, configure dtmf-relay h245-signal h245-alphanumeric and then try the call again. I assume it's failing when you call from the POTS side into the VoIP based IVR.
If you are calling out from the IP phone through POTS to the IVR system, it should work out of the box, even without configuring the above.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...