i've installed CME 7.0 IOS: 12.4.20T. now i am having a 1 problem which is as follows:
when any call comes in goes to Auto-Attendant and the main greeting gets played with different options e.g. press 1 for dial-by-name, Press 2 for dial-by-ext ... etc
those users who have regular cell phones ( like Black Berry, Nokia etc) when they press any option it works for them but few callers are using touch screen phones from nokia or from any other company... so when they press any option, nothing happens
this is what i've configured to direct the calls to AA:
Particular reason that you are using 12.4(20)T? do a sh voice dsp and tell me what your dspware is? Also are you using any hardware or software MTP's? Please paste the entire config.. try 12.4(15)T7 if you don't need 12.4(20)T for some reason..
you say a few callers (with touchscreen phones) are not working, but the bulk are? Based on that information, it sounds as though your config is correct. On one of those touchscreen cell phones, when they touch the number is a DTMF tone played? Have you looked at the setting of those phones to ensure that (once a call is connected) you don't have to send a confirmation key (like enter or #) to encourage the phone to send the digit?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...