I'm trying to figure out how to change the duration of DTMF digits for calls to the PSTN. We are using CCM 4.1(3) and all gateways are MGCP. Everything I've read says that the duration is fixed and cannot be modified. Aynone know any different?
Did you get a chance try out the following voice-port commands
I am thinking it might help, because once the gateway gets the DTMF from the VoIP side, it would use whatever is configured under the voice port when sending the signal out that port. Never tested this though. Please post the results, if you get a chance to test this.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...