I have a customer who will be implementing CCM and Unity in a dual switch integration with their Nortel Option 61.
As you know this will involve Dialogic Cards on the Unity server to integrate with the Nortel. Their is also a PBXLink 48 box that will integrate via serial RS232 to the Unity server and also from the PBXLink 48 box Two DIGITAL lines to the Nortel Option 61.
My question is. The customer needs to run the digital lines between the Nortel and the PBXLink 48 box and they reside in different physical rooms. Do you know the specific wiring or pin outs necessary for the digital lines. I need to provide this information to the customer. OH and I looked at the documentation and could not find anything specific to this.
As far as the PBX is concerned, the PBXLink's digital ports are Nortel 2616 digital sets. I think you'd only be dealing with two physical wires. The pinouts are probably the same for any digital phone, and the PBX admin would need to know what they are even if the PBXLink was in the same room as the PBX.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...