Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Duplex problems with 7960

We using IP phones which are connected with Catalysts 19/29 series. If I use auto duplex on switches then the SW ports in phones use 100 or 10mb depend on switch it is connected with but always in half duplex mode.

Is it feature? :)

How can I avoid this using autosensitive on Catalysts?

1 REPLY
New Member

Re: Duplex problems with 7960

Can I talk to 7960 to use always full duplex?

119
Views
0
Helpful
1
Replies
CreatePlease to create content