Re: During a call party the user doesn't know when it ends
that is correct. when the call is over in cisco voip world the system clears the call. if you watch the display you will see this. on a tdm system it gives you a busy signal to remind you to hang up the phone because you are tying up resources. I am not sure and would have to do a test but I believe that the ata should give some sorta of signal to let the user know that the call is over. either a busy signal or a new dial tone.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...