Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

E&M and calling line ID

I have a CAS T1 with E&M signaling and I just found out I can't get Calling line ID on the ICS7750 ASI 8 with WIC-1MFT card because that card does not support E&M feature group d ( which does not make any sense at all )....anyway....what are my options now besides having to spend the money for an entire PRI???

Manish

1 REPLY

Re: E&M and calling line ID

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources online at http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

118
Views
0
Helpful
1
Replies
CreatePlease to create content