Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

E&M between Alcatel and 1750s

I' getting a short dialtone from the voice port.

There is not enought time to capture all dialed

digits.

If I put a ground in RJ45 PIN 2, the dialtone

is enoughtly long to dial and to capture all digits.

But the ground has to be released else the voice

port is always busy.

bit@ibw.com.ni

1 REPLY

Re: E&M between Alcatel and 1750s

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

128
Views
0
Helpful
1
Replies
CreatePlease to create content