Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E&M card does not sync with Ericson PABX MD -110

We are implementing VOIP for a client's private network. The setup is like this: a 3640 with E&M cards is connected to an Ericson PABX MD -110. We already have the pinouts correct and we used type 1, four wire operation and imeadiate as the signaling paramaters but the pbx senses that the cards are not in sync. Should we change the parameters? We also tried to use the troubleshooting guide available in CCO but to no avail.

Note: the PBX and the router are not on the same Building so we used some of the 25-pair of cable that runs about 50 to 60 meters that terminates to panels. From these panels we utilized four pairs to connect to the Router. We also provided common grounding on the PBX and the router.

Any help would be appreciated.

Thanks

  • Other Collaboration Voice and Video Subjects
1 REPLY
New Member

Re: E&M card does not sync with Ericson PABX MD -110

Use is configuration for this PABX. This PABX IS for wire. Contact e-mail lucianosantos@yahoo.com.br

!

voice-port 1/0/0

cptone BR

timing digit 500

timing inter-digit 500

timing percentbreak 60

description Porta de VOZ E&M - ERICSSON MD110

type 5

signal immediate

!

192
Views
0
Helpful
1
Replies
This widget could not be displayed.