Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E&M Circuit doesn't release right away

When a user connected to a PBX hangs up the phone, the E&M line to the router doesn't free up right away. Is there a command that would resolve this issue?

1 REPLY

Re: E&M Circuit doesn't release right away

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

91
Views
0
Helpful
1
Replies
CreatePlease to create content