Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

E & M troubleshooting

I have a connection plar setup at 2 routers across a wan link i can reach the other as it shows the other end port seized when i do show voice port summary but i cannot dial any number it doesnt accept any numbers dialed when reached the other end PBX

what could be the possible problems

2 REPLIES
New Member

Re: E & M troubleshooting

Have you configured DTMF Relay.

Also make sure the E&M is set to DTMF as Pulse is not supported on Plar connections

New Member

Re: E & M troubleshooting

i tired making local calls by diverting the plar to dial one of my pots it works without dtmf anyways i tried configuring dtmf too any other suggestions :(

208
Views
0
Helpful
2
Replies
CreatePlease to create content