Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

E&M-Wink with ANI

I have a T1 CAS in a Catalyst 4224 as an H.323 Gateway to CM 3.2. Provider sends ANI in the form of *ANI*DNIS* using their E&M Wink Signalling. I have been told told that Cisco does not support ANI with their version of E&M Wink. My provider is not able to use E&M FGD or EANA-FGD as suggested. Any other suggestions out there that might make this work? Thanks.

Brian

1 REPLY

Re: E&M-Wink with ANI

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

120
Views
0
Helpful
1
Replies
CreatePlease to create content