Are you trying to configure this as a E1 PRI for transporting voice calls ?
set both sides with linecode, framing and a pri-group command specifiying number of channels. Under the D channel, set one end as network side and other end as user side (defaults). (isdn protocol-emulate network | user)
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.