04-30-2009 12:54 AM - edited 03-13-2019 06:18 PM
I have the following connections:
TELCO SWITCH <---E1---> 2851 <---MGCP---> Call manager 4.1(3)
I notice that when:
- I make an outbound call my gateway (2851)choose a high-number b-channel
- out telephony system receive an incoming call on a low-number b-channel
Is it normal or is it best if the channel-selection is the same (for example ascending order)?
Thanks
antonio
Solved! Go to Solution.
04-30-2009 03:40 AM
it's normal for it to work that way, otherwise chances of selecting both the same channel at the same time are higher. i wouldn't recommend you to move anything unless explicitly advised by your telco
HTH
java
if this helps, please rate
04-30-2009 03:40 AM
it's normal for it to work that way, otherwise chances of selecting both the same channel at the same time are higher. i wouldn't recommend you to move anything unless explicitly advised by your telco
HTH
java
if this helps, please rate
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: