Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

E1 channel selection

I have the following connections:

TELCO SWITCH <---E1---> 2851 <---MGCP---> Call manager 4.1(3)

I notice that when:

- I make an outbound call my gateway (2851)choose a high-number b-channel

- out telephony system receive an incoming call on a low-number b-channel

Is it normal or is it best if the channel-selection is the same (for example ascending order)?

Thanks

antonio

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: E1 channel selection

it's normal for it to work that way, otherwise chances of selecting both the same channel at the same time are higher. i wouldn't recommend you to move anything unless explicitly advised by your telco

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1 REPLY
Cisco Employee

Re: E1 channel selection

it's normal for it to work that way, otherwise chances of selecting both the same channel at the same time are higher. i wouldn't recommend you to move anything unless explicitly advised by your telco

HTH

java

if this helps, please rate

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
172
Views
5
Helpful
1
Replies
CreatePlease to create content