Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 line

Hi,

what do I have to know from my teleco company about E1 line that they provide to configure it on VWIC2-1MFT-T1/E1.

20 channels will be used.

regards

Slawek

3 REPLIES
New Member

Re: E1 line

You'll need to know which channels they're using and only enable those on your gateway.

(NB: channel 16 is the control channel)

You will also need to know the framing type (CRC4 or NO-CRC4)

Here's all I had to do to set it up recently, which I split into 2 groups to match the PBX's, although you don't have to.

card type e1 0 0

controller E1 0/0/0

framing NO-CRC4

ds0-group 0 timeslots 1-15 type e&m-immediate-start

ds0-group 1 timeslots 17-30 type e&m-immediate-start

Good Luck

New Member

Re: E1 line

is there a rule to always use the lowest 'timeslots'? I mean, if we need 20 channels we will use 1-15, then 17-21 ?

I thought E1 supports 31 channels + 1 control channel, wich gives 30 useable timeslots, how is it?

regards

Slawek

New Member

Re: E1 line

I don't believe that there's any rule, purely depends on how they configure their end but it would be logical to implement it as you suggested.

Correct - 30 data channels (1-15 & 17-31).

If you don't enable the same timeslots as the provider then the caller will intermittently get silence if they get connected on a mis-matched channel

108
Views
4
Helpful
3
Replies