Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

E1 R2 integration with Panasonic PBX

Hi,

I'm trying to integrate cisco H323 voice gateway 2951 with panasonic PBX using E1 R2.

Call from ip phone to PBX works well, but call from PBX's Analog Phone to Cisco IP Phone doesn't work.

When I debug voice ccapi, the calling and called number is empty.

The PBX is panasonic KX-TDA-100 with KX-TDA0188-XJ E1 module.

The module doesn't support PRI.

Here are my configuration :

!

isdn switch-type primary-qsig

!

controller E1 0/0/0

ds0-group 1 timeslots 1-15,17-31 type r2-digital dtmf dnis

cas-custom 1

  seizure-ack-time 30

  release-ack

  dtmf timer inter-digit 500

!

Configuration and debug is attached as below.

Any suggestion is deeply appreciated.

Thanks,

Wengkie K.

766
Views
0
Helpful
0
Replies