From the TAC side of the house, yes, I have been assisting 2 customers that are actively deploying the CER solution. After a few initial configuration issues, we now have the CER solution working. As for how satisfied...hard to say. You really can't tell how well it works until you have an emergency. In the testing we have done, it worked as expected.
We are evaluating the product also. We were informed that with our assignmnet of DIDs to each device that an additional set of DIDs were needed to enable the CER to send the cubicle location to the PSAP with the 911 call. Other plans can be used where you build zones in your building and the PSAP would know a general zone from where the 911 call originated. We have a great deal of employee movement in our building and desired the cubicle location option, but not the cost of the additional DIDs. We are still evaluating though.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...